Tennant IRIS T300, Руководство оператора

Страница: 16 / 57

OPERATION
16
Tennant T300e/T300 (03- 2015)
2. Remove the debris tray by sliding it out from the
scrub head (Figure 23).
FIG. 23
3. Remove the idler plate from the scrub head by
unscrewing the yellow knob (Figure 24).
FIG. 24
4. Slide the brushes into the scrub head and connect
the slotted ends of each brush into the drive hubs
(Figure 25).
FIG. 25
5. Connect the idler plate to the brush ends and
reattach the idler plate. Make sure the idler plate
hooks are engaged before tightening knob (Figure
26).
FIG. 26
6. Replace debris tray.
FILLING SOLUTION TANK
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine, remove key
and set parking brake if equipped.
Remove the solution tank lid and fill the solution tank.
Stop filling tank when the level reaches the “3/3” mark
on the solution tank drain hose indicator (Figure 27).
ec-H2O Scrubbing - Only use cool clean water (less
than 21

C). Do not use hot water or add conventional
floor cleaning detergents. An ec-H2O system fault will
occur if cleaning detergents are added.
Conventional Scrubbing - Use hot water (60

C
maximum). Pour a recommended cleaning detergent
into the solution tank according to mixing instructions
on the container.
NOTE: Do not use the ec-H2O system when there are
conventional cleaning detergents in the solution tank.
Drain, rinse, and refill the solution tank with clear cool
water before operating the ec-H2O system.
WARNING: Flammable materials can cause an
explosion or fire. Do not use flammable materials
in tank(s).
ATTENTION:
For Conventional Scrubbing, only use
commercially approved cleaning detergents. Machine
damage due to improper detergent usage will void the
manufacturer’s warranty.
FIG. 27
The solution tank fill- port is equipped with two hose
clips to hold hose while filling. The two clips are
different hose diameter sizes (Figure 28).
FIG. 28