OPERATION
Tennant T300e/T300 (03- 2015)
25
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE-OPERATION CHECK LIST
-
Sweep area and remove any obstructions.
-
Check brushes/pads for wear and damage.
-
Check squeegee blades for wear and damage.
-
Confirm recovery tank empty and screen and
debris tray is clean.
-
Check scrub head skirt for wear and damage.
-
Cylindrical brush model - confirm scrub head
debris tray is empty and clean.
-
ec-H2O Scrubbing: Confirm solution tank is filled
with clear cool water only.
-
ec-H2O Scrubbing: Ensure all conventional
cleaning agents/restorers are drained and rinsed
from solution tank.
-
Check machine for proper operation.
OPERATING MACHINE
For T300 control panel operating instructions, see
CONTROL PANEL OPERATION.
1. Release the parking brake lever, if equipped (Figure
69)
2. Turn the key to the on ( I ) position (Figure 69).
FIG. 69
3. ec-H2O models - The ec-H2O system will
automatically turn on at start up. To turn off the
ec-H2O system, press the ec-H2O switch located
below the key switch (Figure 70).
ATTENTION:
During first time use and after replacing
the water conditioning cartridge, the ec-H2O system
will automatically override the selected solution flow
rate for up to 75 minutes.
ATTENTION:
If cleaning detergent is accidentally
cycled through ec-H2O system, immediately turn the
ec-H2O system off. Drain solution tank, refill with cool
water and operate the ec-H2O system to flush out
detergent.
T300e models -
T300 models with Membrane control panel -
FIG. 70
ec-H2O INDICATOR
CONDITION
Solid blue
Normal operation
Blinking blue/red
Water conditioning
cartridge expired.
Replace cartridge.
Solid or blinking red
See Service Indicator
Codes.
4. Lower the scrub head to the floor by stepping on
the scrub head lift pedal as shown (Figure 71).
FIG. 71
5. Lower the squeegee assembly to floor by stepping
on foot pad as shown (Figure 72). To raise
squeegee assembly, place toe under foot pad and
lift. The vacuum motor will start when squeegee
assembly is lowered.
FIG. 72
Содержание IRIS T300
Страница 49: ...SPECIFICATIONS Tennant T300e T300 03 2015 49 1095 mm 772 mm DUAL DISK MODEL 1314 mm 660 mm...
Страница 50: ...SPECIFICATIONS 50 Tennant T300e T300 03 2015 1095 mm 772 mm CYLINDRICAL BRUSH MODEL 1283 mm 635 mm...
Страница 51: ...SPECIFICATIONS Tennant T300e T300 03 2015 51 1095 mm 772 mm ORBITAL PAD MODEL 1245 mm 521 mm...
Страница 52: ...SPECIFICATIONS 52 Tennant T300e T300 03 2015...
