Tennant IRIS T300, Руководство оператора

Страница: 28 / 57

OPERATION
28
Tennant T300e/T300 (02- 2016)
CIRCUIT BREAKER PANEL
The machine is equipped with resettable circuit
breakers to protect the machine from a current
overload. If a circuit breaker trips, disconnect the
battery cable connection and reset the breaker by
pressing the reset button after the breaker has cooled
down. Reconnect the battery cable connection. If the
circuit breaker does not reset or continues to trip
contact service personnel.
The circuit breaker panel is located near the battery
compartment and identified as described below
(Figure 82).
FIG. 82
Circuit
Breaker
Rating Circuit protected
CB1 4 A Key switch, control board
CB2 4 A
ec-H2O module
CB3 4 A
ec-H2O pump
CB4 30 A Propel
CB5 37 A Brush motor (T300e)
CB6 20 A
Vacuum motor (T300e)
FOR SAFETY: When servicing machine, all repairs
must be performed by trained personnel.
HOUR METER
The hour meter records the number of hours the
machine has been operated. Use the hour meter to
perform specific maintenance procedures and to record
service history (Figure 83).
FIG. 83
DRAINING TANKS
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine, remove key
and set parking brake if equipped.
DRAINING RECOVERY TANK
Drain and clean the recovery tank daily and between
solution tank refills.
1. Transport the machine to drain area.
2. For models equipped with drain hose caps, hold
the hose upward, remove cap then slowly lower
hose to drain. For models equipped with flow
control valve drain hose, lower hose and slowly
open valve to drain (Figure 84).
FIG. 84
NOTE: When using a bucket to drain the machine, do
not use the same bucket to fill the solution tank.
3. Remove and clean the float shut-off screen (Figure
85).
FIG. 85