TeMec Drive AZ2, Руководство пользователя

Страница: 12 / 52

AZ
2
USER MANUAL
ST.TEC.003.EN Rev. 2.1
12 / 52
3. INSTALLATION AND WIRINGS
!
Read carefully the safety precautions reported in 1.3 and 1.4 before installing the drive!
Follow the instruction reported below to install the drive and integrate it into your system.
3.1. Installation environment
Remember that the drive is an electronic device; check carefully that the installation environment is
appropriate:

do not install in any location with high temperature, high humidity, moisture condensation and
freezing;

avoid installing location where there is the possibility of exposition to water, large amounts of
dust, metallic fragments or corrosive gases;

operate in areas where the temperature is within the limit temperatures reported in Table 1;

do not install in any location that can be subject to large amounts of vibrations.
3.2. Mechanical installation

Install the drive being sure that no metal part is in contact with the bottom side of the board.
The contact with the exposed tracks may cause electric shock or fire.

With reference to Figure 1 and Table 2, use S1 mounting holes for the mechanical installation.

Install the drive in vertical position, with the power terminal on the bottom side and so that the
fins of the optional heat sink result in vertical position.

When installing the drive, leave at least the distances shown in Figure 3 so that the wiring can be
made easily and the drive can dissipate the heat generated during the operation.

In case of multiple installations align the drives horizontally, leaving at least the distances shown
in Figure 3.
AZ
2
AZ
2
5 cm
5 cm
5 cm 3
cm
Figure 3: minimum distances for mechanical installation