Telpar MTP-1500, Руководство пользователя

Страница: 34 / 64

Page 34 of 64
in the user defined mode.
Function 3 allows setting of the
memory switches. +m=03 hex,
p1+p2*256 can vary from 10 dec to
65530 dec. The data structure is a 1
followed by b8 through b1. a1 (01
hex through 08 hex) specifies the
memory switch to be changed. b8
represents position 8 of that
memory switch and so on through
b1 represents position 1 of that
memory switch then another a
followed by b8 through b1 can
follow as specified by the values of
p1 and p2. The values for each b
are 30 hex to set a switch OFF, 31
hex to set a switch ON, or 32 hex to
leave a switch unchanged. 32 hex
should be sent for the “reserved”
switches. The switch changes made
become effective after a reset or
power cycle. Running a self-test
printout can check the switch
settings. Frequent writes may
damage the NV memory. Maximum
recommended usage is 10 times
per day.
Function 4 causes the printer to
transmit the settings of a memory
switch. +m=04 hex, p1=02 hex,
p2=00 hex. The data byte value is
from )1 hex through 08 hex to
specify which memory switch is
being checked. The eleven data
bytes transmitted are 37 hex, 21
hex, 8 data bytes representing the 8
switch positions, and 00 hex. The 8
data bytes are transmitted in the
order of switch position 8 through
switch position 1. For each switch
position, the data sent will be 30
hex (an ASCII 0) if the switch is
OFF or 31 hex (an ASCII 1) if the
switch is ON.
Set
adjustment
values GS ( F +p1
+p2 +a +m
+n1 +n2 1D 28 46 04
00 +a +m +n1
+n2 Effective only when the BM sensor
is enabled. +a = 01 hex selects the
function for the position to start
printing when used by FF or GS FF
commands. +a = 02 hex selects the
function for the position to start
cutting when used by the GS V
command. +m = 0 (either 00 hex of
30 hex) specifies a forward paper
feed. +m = 1 (either 01 hex of 31
hex) specifies a reverse paper feed.
(n1+n2*256)*0.125 mm specifies
how much to feed. The default of all