Telpar MTP-1500, Руководство пользователя

Страница: 24 / 64

Page 24 of 64
instruction standby the
feed button is always
enabled but will not feed
paper.
Forward line
feed for n
character
lines ESC d +n 1B 64 +n Print if needed then feed
paper n character lines.
Range = 0 to 255dec.
Maximum amount of
paper fed = 1016 mm
(40”). Can feed past
marks in BM mode.
Select
Character
code table ESC t
+n
1B 74 +n See section 5.3 -
Character Sets
Set/Reset
Inverted print ESC
+n
1B 7B +n LSB = 1, upside-down
printing. LSB = 0, normal
printing. This command
must be received at the
start of a line to be in
effect for that line. Does
not apply in page mode.
Select
character size GS ! +n 1D 21 +n Characters can be printed
in sizes from 1 to 8 times
normal in either width or
height. Bits 0, 1, and 2 set
the character width
multiplier. Bits 4, 5, and 6
set the character height
multiplier. A value of 0 =
Normal size. Does not
apply to HRI characters
when printing bar codes.
See ESC !.
Test print GS ( A
02hex
00hex +n
+m 1D 28 41
02 00 +n
+m n = 0 or 1 or 2 (00, 01,
02, 30, 31, or 32 hex).
m=1 (01 or 31 hex)
causes a Hexadecimal
dump print pattern. ). m=2
(02 or 32 hex) causes a
Printer Status print
pattern. m=3 (03 or 33
hex) causes a “barber
pole” print pattern. Must
be received at the start of
a line. A cut is performed
following the print test.
The printer is reset
following the print test,
even download characters
or bit image are erased.
Reverse video GS B +n 1D 42 +n Bit 0 = 0 (default) turns off
and bit 0 = 1 turns on
reverse video printing.
Does not apply to bit
image, user-defined bit
image, bar codes and the
HRI part of bar codes, or
spaces skipped by HT,
ESC $, or ESC \