Installation
71
For a Wall Mount Phone
When the DP200 Display phone is assembled for wall
mount use, the upper end of the housing is tilted back, as
shown in Figure 3.
1. Plug the short line cord into the line jack in the
housing.
2. Turn the baseplate face down so that its narrow
end is toward the upper half of the phone
housing.
3. Thread the free end of the line cord up through
the hole in the center of the baseplate. The cord
should come out the back side of the baseplate.
4. Insert the baseplate mounting posts into the
lower pair of mounting post holes in the housing.
5. Insert the two provided screws in the phone to
hold the baseplate.
6. Squeeze the baseplate latch into the locking slot
on the housing. Verify the baseplate is firmly
attached, and turn the phone right side up.
Figure 3
Wall Mount
installation
