Tektronix TLA715 Series, Руководство по обслуживанию

Страница: 92 / 147

Removal and Installation Procedures
TLA715 Dual Monitor Portable Mainframe Service Manual
6- 29
Power Supply
You will need a screwdriver with a size T-15 Torx tip to perform this procedure.
Use the following procedure to remove the power supply:
1.
Do the removal procedures for
Bottom Cover and Feet
(page 6--24),
Top
Cover (page 6--25), and Right Side Cover (page 6--27).
2.
Remove the four screws from the right side and the four screws from the
bottom that secure the power supply to the chassis (see Figure 6--14).
Remove power
supply screws (4)
Remove screws (4)
Power supply
Figure 6- 14: Power supply removal
3.
Pull on the handle to remove the power supply from the chassis.
NOTE
. Replacement power supplies do not come equipped with a power supply
panel or handle.
4.
Remove the two inner screws connecting the handle to the power supply.
(See Figure 6--15) and then lift off the plastic handle mount and handle.
5.
Remove the panel from the power supply by lifting it off.
Removal