TeeJet UniPilot Pro, Руководство по установке, Страница: 9 / 20

3
98-05342 R1 EN
UniPilot ® Pro
CHAPTER 2 – UNIPILOT PRO INSTALLATION
The UniPilot Pro installation process is described below. A detailed process for each step is described in the following sections.
1. Install the Main Gear on the steering wheel
2. Attach the Anti-rotation Pin
3. Install the ESD
Refer to Installation Kit Components in the Components section to identify the parts used in this section.
INSTALL THE MAIN GEAR ON THE STEERING WHEEL
The goal of this section is the installation of the main gear on the steering wheel. Through the use of switch kits, main gears can be installed
and left on multiple vehicles allowing the user to move the ESD.
Install the Main Gear around the Steering Column
1. Remove the 2 hex screws from the Smaller section of the Main
Gear.
Figure 3: Main Gear Hex Screws
2. Remove the Smaller section by pulling downwards.
NOTE: Tolerances are tight, pull directly downwards on the
smaller section.
Figure 4: Main Gear Smaller Section
3. Install the larger section under the steering wheel around the
steering column. Install with the gear side on the top side, closest
to the steering wheel.
NOTE: Weave the gear around the steering wheel spokes
if necessary, certain columns may be too thick for the gear
opening.
Figure 5: Main Gear Installed
4. Reinstall the smaller section using care to push directly upwards
on the sector, this is a very tight fit.
NOTE: To facilitate the fit between the two gear sections, you
may need to apply a drop of oil to assist in aligning the two
gear sections.
5. Reinstall and secure the 2 hex screws. At this point the main
gear is assembled around the steering column below the
steering wheel. The gear is free to move around and must now
be clamped to the steering wheel.