TeeJet UniPilot Pro, Руководство по установке, Страница: 10 / 20

4
www.teejet.com
UniPilot ® Pro
Examine Steering Column and Steering Wheel
Examine the steering wheel underside to determine if a spacer is
necessary. A steering wheel with a soft covering material usually
requires installation of a spacer to avoid interference with the ESD
housing. Flat steering wheels also require the addition of a spacer to
prevent interference between the steering wheel and ESD when the
wheel is turned.
Install Spacer (If Needed)
Install the spacer around the steering column between the steering
wheel and the main gear. Flex the plastic spacer as needed to
clear the steering wheel spokes. The large chamfer on the outside
diameter of the spacer ring should be facing the main gear.
NOTE: Two spacers with different thicknesses are included in the
kit. Select the thinnest spacer that provides the sufficient
clearance between the steering wheel and the ESD.
Figure 6: Installing Spacers - Line up angles
Figure 7: Spacer Installation
Install the Clamp Ring
1. The gear is free to move around and must be now clamped to
the steering wheel. This procedure will install and center the ring
gear for typical 3 spoke shaped steering wheels.
2. Place the clamp ring on top of the steering wheel and install a
minimum of 6 hex screws. Install a screw on each side of every
spoke keeping the screws as close to the spokes as possible. At
this stage keep the screws fairly loose to allow for centering.
NOTE: Two lengths of screws are provided in the kit to
support different thicknesses of the steering wheel spokes.
Select the shorter of the two screws that still provides full
thread engagement.
3. With the main gear clamped loosely, rotate and move the gear
until 3 screws touch the three spokes evenly. Figure 9 shows the
main gear rotated counter-clockwise until three of the mounting
screws touch the steering wheel spokes evenly. This procedure
will help to automatically center the gear under the steering
wheel.
Figure 8: Installing Top Ring