TeeJet UniPilot Pro, Руководство по установке, Страница: 11 / 20

5
98-05342 R1 EN
UniPilot ® Pro
Figure 9: Centering Ring Gear
The red circles indicate which screws are touching the spokes
4. Check the installation by rotating the steering wheel and
watching for off-center movement of the main gear. Repeat the
centering process as necessary.
5. Tighten the screws with an Allen key. Torque to 6 in-lb (0.7 Nm).
Tighten the screws in a cross-pattern (as opposed to tightening
each screw in a clockwise or counter-clockwise order).
NOTE: Do not over-tighten the clamp ring screws. This may
cause the ring gear to warp or damage the steering wheel
spokes.
6. Check the installation again after tightening by rotating the
steering wheel and watching for off-center movement of the main
gear. Repeat the centering process as necessary.
7. Snap the plastic cover over the top ring.
Figure 10: Installing Plastic Cover
ATTACH THE ANTI-ROTATION PIN
1. Choose the desired ESD orientation. The ESD can be mounted
in any orientation the user chooses. Consider the following when
choosing an orientation:
• Ease of installing anti-rotation bracket.
• Access to the Power Switch.
• Avoid locations where a knee could accidently press the power
switch.
• Avoid blocking the vehicle’s steering column controls and
indicators.
• Cable routing with minimal obstruction in the cab.
2. Based on your preferred orientation, choose one of three
locations for the Anti-rotation Pin.
Figure 11: Anti-rotation Pin Kit