TeeJet UniPilot Pro, Руководство по установке, Страница: 6 / 20

iv
www.teejet.com
UniPilot ® Pro
Caution Alerts
The UniPilot Pro system installer and manufacturer disclaim any responsibility for damage or physical harm caused by the failure to adhere to
the following safety requirements:
CAUTION: The UniPilot Pro system does not detect obstacles in the
vehicle’s path. The vehicle operator must observe the path
being driven and take over steering manually if an obstacle
must be avoided.
CAUTION: The UniPilot Pro system does not control the speed of the
vehicle. The operator must manually adjust the speed of the
vehicle to keep the vehicle safely under control.
CAUTION: To avoid possible damage to electronic circuits caused
by electrostatic discharge, never touch the contacts on the
SCM Pro electrical connectors at any time.
CAUTION: Make sure the assembly does not interfere with any of
the vehicle control levers on the steering column.
CAUTION: Make sure that the main gear race has properly engaged
on the three rollers before closing latch. If the race is not
engaged properly, you risk damaging the ESD and steering
wheel while the UniPilot Pro system is operating.
INSTALLATION REQUIREMENTS
Standard Tool Requirements
The installer is assumed to have a complete set of common installation tools including:
• 7/64" Allen Wrench
• 5/32" Allen Wrench
• 1/4" Open Wrench • 1/4" Nut Driver
• Torque wrench 0 to 20 lb-in (0 to 2 Nm), for 5/32" hex bit
Vehicle Requirements
Prior to installing the UniPilot Pro system, verify the following items on the vehicle:
• The vehicles steering system is in good working order. Drive
the vehicle to verify this prior to beginning the installation. There
should be no play in the steering and the vehicle should turn
proportionally the same to the left and right.
• The vehicle’s electrical system and battery must be in good
working order.
• The vehicle should be fully cleaned before installing the
UniPilot Pro system. A clean vehicle will improve the overall
installation and cable routing.
If any issues are discovered with the vehicle, they must be repaired prior to beginning the UniPilot Pro installation by a qualified service
person for the vehicle.
NOTE: This installation manual, vehicle specific installation manuals, and sub-kit manuals contains valuable information for servicing the
UniPilot Pro system. After the installation is complete, store all of these manuals in a safe place for future reference.
Vehicle Inspection
Prior to installing the UniPilot Pro system, confirm that the vehicle and the vehicle’s steering system are in good working order by driving it
around. In addition, verify the following items:
• Verify that you can turn the steered wheels from lock to lock.
• Verify the vehicle steers straight and does not pull to one side
when driving in a straight line.
• Verify that there are no oil leaks.
• Check for loose or worn steering components.
If any part of the vehicle is not in working order, have the system serviced by a qualified technician prior to beginning the UniPilot Pro
installation procedure.