TeeJet UniPilot Pro, Руководство по установке, Страница: 16 / 20

10
www.teejet.com
UniPilot ® Pro
UniPilot Pro Harness Installation Procedure
The UniPilot Pro system cable harness installation steps are described below. Follow them in order, referring to Figure 20 as necessary. This
procedure assumes that you have connected your Steering Control Module (SCM Pro) to your Aeros or Matrix Pro GS console. Refer to
FieldPilot Pro & UniPilot Pro documentation for further information.
1. Connect the ESD to UniPilot Pro Harness 30 pin connector to the SCM Pro and tighten the connector screw using a 1/4" nut driver.
Tighten to 15 to 20 in-lbs (1.7 to 2.2 Nm). Use only the recommended nut driver and do not over tighten.
Figure 21: Connect UniPilot Pro Harness to SCM Pro
2. Connect the UniPilot Pro Harness to the ESD. Carefully align the circular connector against the mating connector under the ESD and
rotate until it fits. Then rotate the external sleeve clockwise to lock the connector. To disassemble, rotate the outer connector sleeve
counterclockwise. Never force the connector.
Figure 22: UniPilot Pro Harness to ESD Connection
3. Route the cables in such a way to prevent damage.
4. Installation of the ESD is complete refer to the FieldPilot Pro & UniPilot Pro User Manual for vehicle setup and calibration and operation
instructions.