TeeJet AEROS9040, Руководство пользователя

Страница: 43 / 50

39
98-01504-ENUS R2
Aeros 9040 Field Computer
Self-propelled
ISOBUS Sprayer Settings:
1. Press UNIVERSAL TERMINAL bottom tab .
2. From the Main setup screen , select
Machine
.
3. Select
OEM
then enter the access code as needed.
4. Select
Implement Geometry
:
5. Establish values for:
►Connector type:
Selfpropelled - front
or
Selfpropelled - rear
►B=Section X-offset  – measured in parallel to the centerline of
the machine, define the distance from the center of the rear axle
to the implement
Aeros Settings:
1. Press SYSTEM SETUP bottom tab .
2. Press CONFIGURATION side tab .
3. Press
Implement
.
4. Select Implement type
Straight
.
5. Press Implement type NEXT PAGE arrow to set up specific
implement options.
6. Establish values for:
►Connection Point In-line Offset Direction  – define the
direction as
Forward
or
Backward
based on ISOBUS Sprayer
connection type
►Connection Point In-line Offset Distance  – measured in
parallel to the centerline of the machine, define the distance
from the GNSS antenna to the center of the rear axle
►Connection Point Lateral Offset Direction  – define the
direction, either left or right, from the centerline of the machine
to the center of the center of the rear axle while facing in the
machine’s forward direction
►Connection Point Lateral Offset Distance  – define the
distance from the centerline of the machine to the center of the
rear axle
►Implement In-line Offset Direction  – same direction as Aeros
Connection Point In-line Offset Direction
►Implement In-line Offset Distance  – calculated based on
Aeros Connection Point In-line Offset Distance  and ISOBUS
Sprayer B=Section X-offset

entries
►
Front Mount –  -  = 
►
Rear Mount –

+

=

►Implement Lateral Offset Direction  – same direction as Aeros
Connection Point Lateral Offset Direction
►Implement Lateral Offset Distance

– same value as on Aeros
Connection Point Lateral Offset Distance
Figure 29: Front Mount
Figure 30: Rear Mount
– Center of the GNSS antenna
– Center of the rear axle

– Connection Point In-line Offset Direction/Distance

– Connection Point Lateral Offset Direction/Distance (not illustrated)

– B=Section X-offset distance

– Implement In-line Offset Direction/Distance
Three Point Hitch
ISOBUS Sprayer Settings:
1. Press UNIVERSAL TERMINAL bottom tab .
2. From the Main setup screen , select
Machine
.
3. Select
OEM
then enter the access code as needed.
4. Select
Implement Geometry
:
5. Establish values for:
►Connector type:
3-point hitch - front
or
3-point hitch - rear
►B=Section X-offset  – measured in parallel to the centerline of
the machine, define the distance from point to the implement
Aeros Settings:
1. Press SYSTEM SETUP bottom tab .
2. Press CONFIGURATION side tab .
3. Press
Implement
.
4. Select Implement type
Straight
.
5. Press Implement type NEXT PAGE arrow to set up specific
implement options.
6. Establish values for: