22
www.teejet.com
Aeros 9040 Field Computer
NextRow mark B – marks the end point of the
row.
Azimuth Degree – establishes a straight
guideline measured by degrees clockwise from a
north-south baseline. North = 0, East = 90, South =
180, West = 270.
A+ Nudge – shifts the existing guideline to the
vehicle’s current position.
Next Straight Guideline – shows the next straight
AB or Azimuth Degree guideline saved in the current
job.
Next Curved AB Guideline – shows the next Curved
AB guideline saved in the current job.
Next Circle Pivot Guideline – shows the next Circle
Pivot AB guideline saved in the current job.
Next Adaptive Curve Guideline – shows the next
Adaptive Curve AB guideline saved in the current
job.
Return to Point
Mark point – establishes a point at the vehicle
location. Grayed = GNSS is unavailable.
Return to Point guidance – provides distance and
guidance back to an established point.
Delete point – deletes the Marked Point.
Cancel guidance – hides the distance and guidance
back to the marked point.
BoomPilot
Toggles the Automatic Section Control (ASC) on or
off. Grayed = GNSS is unavailable.
Curved Lookahead
Indicates where the current steering will take the
vehicle using a ‘pointer’ as guidance.
Tip fault reset
Clears any tip fault indications.
Refresh GNSS position
Resets the ClearPath filter in the OEMStar receiver.
Boundary and Polygon Options
On any guidance screen, displays exterior boundary, interior boundary
and polygon options.
12
deg
-13
0.0
55
(psi)
Exterior boundaries
Mark exterior boundary – establishes application
area and determines no-apply zones. While creating
an exterior boundary, the boundary line will be to the
exterior of the outer-most section. Grayed = GNSS
is unavailable.
Cancel exterior boundary – cancels mark exterior
boundary process
Finish exterior boundary – finalizes current mark
exterior boundary process. Boundaries can also be
closed by travelling to within a swath width of the
starting point.
Pause exterior boundary – pauses the mark exterior
boundary process
Resume exterior boundary – resumes the mark
exterior boundary process
Delete last marked boundary – deletes the last
marked boundary (interior or exterior) from the
current job. Press again to remove additional
boundaries in order from last to first created
Interior boundaries
Mark interior boundary – establishes application
area and determines no-apply zones. While creating
an interior boundary, the boundary line will be to the
interior of the inner-most section. Grayed = GNSS is
unavailable.
Cancel interior boundary – cancels current mark
interior boundary process
Finish interior boundary – finalizes current mark
interior boundary process. Boundaries can also be
closed by travelling to within a swath width of the
starting point
