To add a new user to a NAC, follow these steps:
1. Click the
Users
button on the
User access
ribbon tab to open the
Users form.
2. On the Users form, click the
New
button in the toolbar to add a new
user record.
3. Enter the required information on the
User
tab.
4. On the
Access
tab, ensure that the Door groups field has a door group
entry that has NAC doors. Click the
Assign
button to open a door
group selection dialog. Select a door group and click the
OK
button.
5. Click the
Save
button in the toolbar to save the user record.
6. On the
Cards
tab, click the
New
button to add a new card. In the Cards
dialog, ensure the
Panel
field is set to the relevant NAC or Challenger
Plus
panel, and enter the card data and PIN as required. Click the
OK
button
when finished.
7. Click the
Save
button in the toolbar to save the user record.
Refer to the
ChallengerPlus Programming Manual
for more information on users.
Refer to the
CTPlus Operators Manual
or CTPlus online help for more
information on the Users form.
Note:
A NAC in Classic mode is limited to 48 bits of card data. A NAC in IP
Direct or IP Extended mode supports up to 128 bits of card data. However, in IP
Extended mode, cards with more than 48 bits of card data cannot be used for
alarm control functionality.
Содержание TS1066
Страница 1: ...TS1066 Network Access Controller Programming Manual P N MAPROG TS1066 REV 1 6 ISS 16AUG19 ...
Страница 4: ...ii TS1066 Network Access Controller Programming Manual APPENDIX B Enclosure Access Restrictions 106 ...
Страница 6: ......
Страница 36: ...See Status and control section for more details depending on the operating mode of NAC ...
