3. On the
Ethernet
tab, set up the Ethernet settings for the NAC (i.e.
IP
address
and
Subnet mask
). Ensure that the
Enable Ethernet
check box
is ticked.
4. Click the
Save
button in the toolbar to save the Comm device record.
Configuring communications path
Configure an IP communications path on the NAC for management software.
Using CTPlus, follow these steps:
1. Click the
Communications
button on the
Panel programming
ribbon
tab and select
Comm paths
to open the Comm paths form.
2.
Select one of the NAC’s communications paths, e.g. communications
path
3 (ensure the record’s associated
Panel
field matches the NAC
panel).
Содержание TS1066
Страница 1: ...TS1066 Network Access Controller Programming Manual P N MAPROG TS1066 REV 1 6 ISS 16AUG19 ...
Страница 4: ...ii TS1066 Network Access Controller Programming Manual APPENDIX B Enclosure Access Restrictions 106 ...
Страница 6: ......
Страница 36: ...See Status and control section for more details depending on the operating mode of NAC ...
