Region number
: Select the region by clicking the
Browse
button, or type the
region number directly into the field.
Low limit:
Minimum number of the people that represent the region.
High limit:
Maximum number of people that represent the region.
Below low limit relay:
Physical address of the relay when the number of people
in the region is less than the low limit.
High limit relay:
Physical address of the relay when the number of people in the
region is more than the high limit.
Deny access when high limit reached:
Access is denied when the number of
people trying to access the region and in the region is more than the high limit.
Release users from region when time zone starts:
Users are released from
the region when the configured TZ starts, forcing them to badge their cards again
to enter the region.
Release users from region when time zone ends:
Users are released from the
region when the configured TZ ends, forcing them to badge their cards again to
enter the region.
Time Zone:
Specify a time zone to apply to the region. Releasing users is only
available when the time zone starts or ends.
Enable high security users:
Users with high security profile are enabled in the
region.
HSU warning time:
Specify the maximum time allowed in minute or seconds,
after no HSU is in the region or the number of the HSU is below or above the
defined range for HSU warning timer to expire.
Figure 6 DGP NAC regions Setup
Содержание TS1066
Страница 1: ...TS1066 Network Access Controller Programming Manual P N MAPROG TS1066 REV 1 6 ISS 16AUG19 ...
Страница 4: ...ii TS1066 Network Access Controller Programming Manual APPENDIX B Enclosure Access Restrictions 106 ...
Страница 6: ......
Страница 36: ...See Status and control section for more details depending on the operating mode of NAC ...
