TM-NANO-3T Combo User’s Manual
45
• Adapter settings
- Use interface
: "YES" is used to activate the Ethernet. If you set this option at "NO", the Ethernet will not work.
- Use DHCP
: "YES" is used to use DHCP (Dynamic Host Configuration Protocol). If you set this option at
"YES", it will automatically detect the correct IP address. "NO" is used when you want to use a certain
fixed IP address. In this case, you need to enter correct addresses in each field.
• Manually setting an IP address
These settings are only needed if you have selected “no“ on the “Use DHCP“ option before.
- IP Address
: You can assign any IP address to you set-top
box. The only expecting is the 192.168.0.1 IP since
it usually is reserved for you internet router and
should there for not be used.
Free IP addresses: 192.168.0.2 - 192.168.0.254
- Netmask
: Enter the subnet mask which usually is
255.255.255.0
- Use a gateway
: Set this option to “yes“ and enter the IP address of the PC or router in your network with internet
connectivity. Usually this is: 192.168.0.1
To save the settings and activate the network connection press the OK button.
• Nameserver setting
Note
: If you have set the “Use DHCP“ option to “yes“ you won‘t have to enter anything here since
this will be done automatically.
- Nameserver
: Enter the DNS-
Server’s IP address of your LAN here. DNS is used to translate a Domain
name to an IP address. Normally, if the Type is set to LAN, there is no need for a DNS entry. If the set-
top box is connected to the Internet over a router,
enter the router’s IP address here.
Press the Green options button if you want to add
a seconds name server and the Yellow options
utton to delete a name sever.