TM-NANO-3T Combo User’s Manual
36
Press OK to activate the automatic scan. This will take some minutes. As the scan proceeds, you
will see the progressive bar and the newly found services underneath.
2-1-4. Manual Scan
[In case of DVB-S/S2 by Tuner A/B]
If you know well enough to configure each exact setting required for manual search of services, you
can do manual scan as well. There are many parameter values that you need to decide as below.
• Tuner
: You need to decide which tuner you want to use for manual scan.
• System
: Here you have two options between DVB-S (SD) and DVB-S2 (HD).
• Frequency
: You need to enter the exact frequency of the transponder that you want to scan.
• Symbol Rate
: You need to enter the exact symbol rate of the transponder that you want to scan.
• Polarity
: Here you have options for Horizontal, Vertical, Circular Left and Circular Right. You need to know
the polarity of the transponder that you want to scan.
• FEC (Forward Error Correction)
: You need to enter the exact FEC value of the transponder that you want to scan.
• Modulation
: Here you have two options for QPSK (SD) and 8PSK (HD).
• Network scan
: Here you have two options for YES and NO. NO is used to scan the transponder (TP) based on
the data that your set-top box currently has. YES is used to scan the TP not just based on the existing
TP data but also using new TP data, if there is TP data newly transported from the TP. Naturally, YES
option takes longer while it may results in a better scan result.
• Clear before scan
: YES is used when you want to delete the existing channel list before you start the automatic scan.
If you want to keep the existing list, select NO.
