TECHNOALPIN M 20 AT, Руководство пользователя

Страница: 15 / 37

TechnoAlpin M20
- 14 -
IMPORTANT
In the case of manual hydrant installation, then this must be opened within 60 minutes.
OPERATION:
Now the snow machine is in operation.
During this phase the following should be considered:

The water pressure will be regulated by means of opening and closing the hydrant.

The switchable jets will be opened and closed depending on the humid bulb temperature, the water
temperature and the water pressure.
Snow control: check the quality of the snow produced where it mostly collects.
There is the possibility to change the set snow quality.
Continually supervise the correct running of the machine, even when it is in automatic mode.
ATTENTION
When the machine is in operation, do not stand in front or at the back of the
running turbine!
At all times (operation, running phase, stop phase,.... the machine):
EBENE 1
WASSERDRUCK
REL FEUCHTE
STATUS
WASSERDURCH WASSERTEMP
LUFTTEMP
LEVEL 1 AIR TEMP. WATER PRESSURE REL. HUMIDITY HUMID BULB TEMP.
STATUS WATER PRESSURE WATER TEMP.
All data can be seen in level 1. The UP and DOWN keys may be used.
Some parameters can be set in level 2, be altered (as will be explained in the following section). The machine sets
itself automatically on the newly given parameters.
You may change to level 3 and alter parameters (as will be explained in the following section).
THE STOP PHASE
Pressing the STOP key , the following appears on the display :