TECHNOALPIN M 20 AT, Руководство пользователя

Страница: 14 / 37

TechnoAlpin M20
- 13 -
iIlustration 4
INFORMATION
If the words: START , STOP , READY!, WAIT ... and OFF appear on the display the UP or DOWN
keys can be pressed, to see the description of the shown value in the upper lines.
After the starting phase, for which the heating will always remain switched on, the heating will be switched on and
off for variable time periods, depending on the air temperature.
At the same time the snow machine starts positioning. The turbine swings downwards, to the end switch, then it
goes to the set position (in the case of a built-in electric motor).
In the meantime the compressor will be switched on, its warm running time depends on the measured air
temperature.
On the display the letter
K appears on the second line position as will be seen in illustration 5
:
EBENE 1
WASSERDRUCK
REL FEUCHTE
STATUS
WASSERDURCH
WASSERTEMP
LUFTTEMP
LEVEL 1 AIR TEMP. WATER PRESSURE REL. HUMIDITY HUMID BULB TEMP.
STATUS WATER CAPACITY WATER TEMP
Bild 5
Illustration 5
After the warm running time of the compressor is completed, the valve test will be carried out. If the valve
test is successfully completed, the swinging operation begins (if a swing width is set). Then the turbine may
be brought into use, the letter T appearing on the third line position. ( illustration 6).
Bild 6
Illustration 6
Finally the hydrant will be opened.
ATTENTION (in the case of an automatic hydrant available)!
When a minimum pressure of 8 bar on the jets is not reached within a short time span, then a corresponding error
report will be given and the machine will be halted.
If a smart hydrant such as Hydromat SE, Hydromat 2000 or E-Motor is connected to the snow machine, the
machine will open the hydrant automatically.
Auto - 30 °C
H _ _ 0 Air temp.
Auto - 30 °C
H K _ 0 Air temp.
Auto - 30 °C
H K T 0 Air temp,