25
Display of DL outputs
DL outputs can be programmed on the controller to which the RAS+DL is connected. They can then
be found below the usual display values on the RAS+DL. No settings are necessary on the RAS+DL
itself. If a sent value is detected, it is automatically displayed and also hidden in the event of a value
failure (timeout).
Programming
A DL output is programmed on the controller; the address of the output must be the DL address of
the RAS+DL (see "Addresses in the DL bus network DL ADR"). The index is shown on the display.
In this example, the RAS+DL is given a dimensionless value of
7.0
using a
D
L
o
utput with index
1.
Units are displayed on the line below the display value (if symbols are available for them). If the value
is too long, the name (DA
n
) and then the value itself are shown in a continuous loop.
Parameter settings on the controller
Example:
On the UVR16x2 controller shown here, a DL output has
been programmed, which transfers the measurement
to input 1.
This is displayed on the RAS+DL (DL address 1) as
DA1 100.0 °C
. The value is too long to be shown at
once, and therefore appears as a continuous loop. The
unit is shown below the line.
