28
The signal reported at the controller corresponds to the room temperature changed using the rotary
knob. The following signals are forwarded to the controller according to the switch setting:
The increased values for normal, lowering or standby mode are interpreted internally in the UVR63-H
and in the heating circuit controller function module of the UVR1611. The display in the measured
values overview of the UVR1611 takes place without offset values of the operating mode switch.
Use as a remote control
If the installation location of the room sensor is unsuitable as a reference room, the room sensor
RAS+DL
can also be used merely as a
remote control,
by using
Index 5
as the measured value. Using
this method, a fixed value of 20°C with offset values of the +/- setting and the slider switch are for
-
warded to the controller.
Room sensors with other controllers
In the controllers ESR31 (from version 1.0), ESR21, UVR61-3, UVR63 (from version 5.0) and UVR63-
H (version 5.0 up to 7.1), only the measured room temperature can be evaluated, i.e. without offset
values (index 2); the slider switch and the rotary knob have no purpose with these controllers.
Key operation for the display values is as for the controller UVR1611.
Installation
The sensor can only be used in dry rooms and can be installed directly on a level surface or in a stand
-
ard device enclosure.
The room sensor must be opened for mounting. A small screwdriver is used to press in both the
clamps beneath the temperature selection knob and slider switch while simultaneously raising the
cover. The base plate can now be easily mounted.
• Automatic mode
= Room tempe/- inverse rotary knob
• Normal mode
= Room tempe 50°C +/- inverse rotary knob
• Lowering mode
= Room tempe 100°C +/- inverse rotary knob
• Standby mode
= Room tempe 150°C +/- inverse rotary knob
