programme automatically from the EPGplus data. Both the starting and the ending time of
the programme will be taken over correct to the nearest minute. However, it frequently
happens that the selected programme starts a little earlier or a little later than scheduled. In
this case the start or the end of the programme may be missing from the recording. To
overcome this problem, you can enter a pre- or post-run time for the timer, in steps of one
minute at a time. The timer will then start earlier and end later than given in the EPGplus
data by the entered pre-run and post-run times.
>
Press the
red
function key
Timer
to open a selection window.
>
Use the
arrow keys up/down
to mark the line
Timer settings
.
>
Confirm by pressing
OK
.
A menu will be displayed allowing you to enter the pre-and post-run times.
>
Now use the
arrow keys up/down
to mark the line
Timer pre-run time
and
Timer post-run time
.
>
Use the
numeric keys
to enter the desired pre- or post-run time in minutes.
>
Press the
green
function key
Accept
to save the setting and return to the previous
EPGplus table.
7.16.7.3 EPGplus programme overview
You can use the EPGplus programme overview to display a table with the whole day's
listings for an individual channel. Proceed as follows:
>
Press the
EPG
key.
If you have selected the start category
Overview
, see Point 9.2.3, the “
Now
”
EPGplus table will appear.
>
While the “
Now
” EPGplus table is displayed, press the
green
function key to switch
directly to the channel listings.
or
>
press the
blue
function key
EPG Menu
.
>
In the selection window, use the
arrow keys up/down
to mark the line
Programmes
.
>
Confirm by pressing
OK
.
The day’s overview of the selected channel will now be displayed.
>
You can use the
arrow keys
to move the marker to the desired programme or time.
The individual days of the week are displayed along the lower edge of the screen. If
information is available for the following days, the appropriate fields will be marked.
>
To display the programme content of a specific day, press the corresponding
numeric key
.
Displaying the EPGplus overview for other channels
>
Press the
yellow
function key
Programmes
.
A list of EPGplus programmes will be displayed.
>
You can now proceed to mark the desired channel using the
arrow keys
.
>
Press the
OK
key to display the EPG overview of the marked channel.
7.16.7.4 EPGplus overview by type of programme (genre)
39
7
