TEC B-880 series, Руководство пользователя

Страница: 154 / 180

6-67
6. DIAG. TEST OPERATION EO18-33007
6.6 RAM CLEAR MODE
6.6 RAM CLEAR MODE
In RAM clear mode, various data written on the EEP-ROM can be initialized. There are two clear
functions; Maintenance counter clear and parameter clear in the parameter setting mode. After referring
to the following table specify and clear or initialize the data.
■
RAM Clear Mode Table
Mode Name
NO RAM CLEAR
Function
If you enter the RAM clear mode by mistake, specify this mode to
escape from the RAM clear mode without executing RAM clear.
After replacing the print head, cutter module, ribbon feed/rewind
motor, solenoid and CPU PC Board, clear the maintenance counter.
The following data will be cleared to zero. Confirmation can be made
through the maintenance counter procedure in self test mode. (See
NOTE 1 and 2.)
This clear should be employed when initializing the following parameters
to the settings before shipment. Confirmation can be made through
the automatic diagnostic procedure in self test mode. (See NOTE 1
and 2.)
MAINTE. COUNTER CLEAR
PARAMETER CLEAR
Item
Media distance covered
Print distance
Cut count
Head up and down count
Ribbon motor driving time
Solenoid driving time
Take-up Motor driving time
RS-232C hardware error count
System error count
Momentary power failure count
Initial Value
0.0 km
0.0 km
0 time
0 time
0 hour
0 hour
0 hour
0 time
0 time
0 time
Item
Feed length fine adjustment (PC)
Cut/strip position fine adjustment (PC)
Back feed length fine adjustment (PC)
Print tone fine adjustment
(Thermal transfer) (PC)
Print tone fine adjustment
(Thermal direct) (PC)
Ribbon motor drive voltage fine
adjustment (Take-up) (PC)
Ribbon motor drive voltage fine
adjustment (Feed) (PC)
Feed length fine adjustment (KEY)
Cut/strip position fine adjustment (KEY)
Back feed length fine adjustment (KEY)
Print tone fine adjustment
(Thermal transfer) (KEY)
Initial Value
0.0 mm
0.0 mm
0.0 mm
0 step
0 step
0
0
0.0 mm
0.0 mm
0.0 mm
0 step