TEC B-880 series, Руководство пользователя

Страница: 141 / 180

6-54
6. DIAG. TEST OPERATION EO18-33007
6.4 TEST PRINT MODE
6.4 TEST PRINT MODE
Test print mode contains normal test print and process test print.
6.4.1 Normal Test Print
Eight kinds of test prints are provided in the test print mode. When performing the test print, 7
parameters should be set. The default parameter at power on is as below:
• ISSUE COUNT : 1
• PRINT SPEED : 4"/sec.
• SENSOR : Transmissive sensor
• PRINT TYPE : Thermal Transfer
• TYPE : Batch (without cut)
• LABEL LENGTH : 76 mm
• PAPER FEED : Feed
Operating procedure for the test mode is provided below.
ISSUE COUNT Select “Print Condicton”
by pressing the [PAUSE]
key.
To be continued on
B of the next page.
Press the [FEED] key
or [RESTART] key.
(See NOTE 1.)
Press the
[RESTART]
key.
PRINT SPEED
SENSOR
RIBBON
TYPE
LABEL LEN.
PAPER FEED
Set the print count
To A.
Continued
on section
6.4.2
Process
Test Print.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key twice.
Press the [PAUSE] key.
From
C
on the
next page.
Press the [FEED] key
and [RESTART] key
at the same time.
< 1
D I A G N O S T I C V
> 1 . 0 A
P R N T C O N D I T I O N I
< 3
T E S T P R I N T
>
I S U E C O U N T S