TEC Electronics CANTEC-F2-U, Руководство пользователя

Страница: 4 / 17

Version 12.11.2013 TEC-6050-2 CANTEC-F2 V5
P
a
g
e
4
CAN-bus
2. Pin definition and factory defaults of programmable outputs/inputs
Male pins of black-box 18pin port
Programmable outputs/inputs configuration can be done out via programming (see chapter
4.) or via TEC-PROG tool and software with Windows PC. Factory defaults are predefined
according to table 1. These settings can be restored by resetting the unit (see chapter 5.)
Pin definition and factory defaults of programmable outputs/inputs – table 1
Pin
no. Harness wire
color
Functionality
Factory default
settings
Maximum
current
1
Blue/red Programmable output (+ / -)
with changeable polarity* Alternate hazard
lights control 200 mA
2
Blue/yellow Programmable output (+ / -)
with changeable polarity* Alternate central
locking control 200 mA
3 Black Ground of power supply - -**
4 White/black Programmable output (+) Engine on 50 mA
5 Green/yellow Programmable output (-) Parking brake 50 mA
6 Pink/green Programmable output (+) Brake 50 mA
7 Yellow/red Programmable output (+) Ignition 50 mA
8
Green Programmable input (-) Central locking
c comfort 1.5 mA
9 Blue Programmable input (-) Central unlocking 1.5 mA
10 Brown/red CAN-high of vehicle data bus - -
11 Brown CAN-low of vehicle data bus - -
12
Red +12V of power supply - 750 (4) mA
***
13 Gray/black Programmable output (-) Security 50 mA
14 Gray/blue Programmable output (-) All doors 50 mA
15 Gray/green Programmable output (-) Trunk 50 mA
16 Gray/yellow Programmable output (-) Hood 50 mA
17 Orange/white Programmable input (+) Turn lights activation 1.5 mA
18 Orange/green Programmable input (-) Trunk opening 1.5 mA
* Outputs with changeable polarity. Outputs’ operation with load higher than the indicated
is not guaranteed and may damage the unit.
** Consumed current of output pin 3 depends on the load connected to all negative outputs.
*** Typical current rate is indicated for operation and standby modes. It may change
depending on positive outputs’ load.
Avoid making contact between ground and outputs pins 4, 6, 7 or +12V and outputs pins 5,
13-16. Otherwise the unit is damaged.