Version 12.11.2013 TEC-6050-2
CANTEC-F2 V5
P
a
g
e
9
CAN-bus
output pin 2
locking status is not available)
In most cases the algorithm and polarity are set automatically when recognizing the
vehicle.
7
Hazard lights alternative
control algorithm of
output pin 1
1-5 / -
1 – impulse negative control
2 – status negative control
3 – impulse positive control
4 – status positive control
5 – lamps control (negative)
In the majority of cases the algorithm is set automatically when recognizing the
vehicle.
8
Parking distance control
(PDC) system algorithm –
output functions no. 17-19
1-3/1
1 – “Activation on rear gear”
2 – “Activation on speed”
3 – “Activation on rear gear with priority of
switching off”
“Activation on rear gear” - Front and rear parking sensors are activated when reverse
gear is engaged or by PDC control button (see option no. 9). Deactivation upon speed
reaches 15km/h or by PDC control button.
“Activation on speed” - Front parking sensors are active as long as the vehicle’s speed
is less than 15km/h. Rear parking sensors are active if the vehicle moves back and its
speed is less than 15km/h. Activation (when speed < 15km/h) and deactivation
possible by PDC control button. Automatic (re-)activation on ignition on.
“Activation on rear gear with priority of switching off”. Same algorithm as
“Activation on rear gear”, but if parking sensors have been deactivated by PDC control
button no automatic activation on engaged reverse gear until next ignition on or
activation by PDC control button.
9
PDC control button –
output functions no. 17-19
-/-
Any OEM (factory) vehicle’s button which is
“visible” in CAN-bus can be used. Also any
(negative/positive) button connected to the
corresponding output of the unit. Also the
length of control press can be determined.
PDC control button assigning algorithm. Press and hold the button that you have
chosen as PDC button for the particular time:
Control with short press – keep button pressed less than 2 seconds
Control with long press (2.5 sec) – keep button pressed 3-5 seconds
Control by status (on/off) – keep the button pressed longer than 5 seconds
The LED light is off while the button press is detected. Release the button. The unit
emits one light signal and turns off.
6. of programming sequence (chapter 4.1.)
