Version 12.11.2013 TEC-6050-2
CANTEC-F2 V5
P
a
g
e
5
CAN-bus
3.
Installation
3.1.
Power and CAN connections
Disconnect the vehicle’s battery during installation or changes on the wiring!
C12V, Ground, CAN-high and CAN-low wires of the unit’s harness to the
corresponding wires of the vehicle (see vehicle-specific installation file).
Connect the unit’s black-box to its harness and make sure that all other open end wires of
the harness do not short-circuit.
3.2.
Vehicle recognition
For proper operation, the unit must recognize the vehicle and its specific CAN-bus, thus
vehicle group and sub-group. There are two ways:
3.2.1.
Automatic vehicle recognition
After installing the unit to power and CAN-bus, by carrying out a set of simple actions (see
vehicle-specific installation file for procedure) the vehicle-specific group and sub-group are
defined automatically. To check correctness of group and sub-group the LED issues a number
of light signals (group number – pause, sub-group – pause).
If the unit identifies both vehicle group and sub-group, it emits triple series of light signals,
where the number of long signals corresponds with the group number, while the number of
short signals corresponds with the sub-group number.
If the unit identifies only the vehicle group, it stops emitting short light signals and
periodically emits series of lights signals, where the number of signals corresponds with
vehicle group.
