409-32023
Rev
B
20 of 41
6. To change the values of a counter, click the tool listed in the Maintenance screen.
— When the target count is set to a value, the counter is active. If the target is set to “0,” then the
counter is not active.
— When a target count is exceeded, a message will be displayed on the machine until the count is
reset.
On the Tool Maintenance Data screen, the target count can be set and the count for the tool can be
reset. The service date will be updated, as well as the current date when the count was reset. Press
the Apply button to save the changes. See Figure 28.
Figure 28
2.4.
Integration of Hardware and Software
1. When the software is installed on Windows XP
, the “USB Host for One-Wire Network for using
WinUSB” files are copied to the hard drive. When the USB to one-wire adapter is plugged into the
USB port of the computer, the software driver will need to be installed. To install the driver, follow the
“USB One-Wire Converter Software Driver Installation on Windows XP”.
2.
When Windows XP detects the “Dallas USB Device”, the “New Hardware” wizard should open. See
Figure 29.
Select “No, not at this time”. Then, click “Next”.
3.
Select “Install the software automatically”. Then, click “Next”. See Figure 29.
Figure 29
“No, Not at This Time” Selected
“Install the Software Automatically” Selected
Downloaded From
