409-32023
Rev
B
12 of 41
g. In the center of the dialog, locate and double click
“Internet Protocol Version 4(TCP/IPv4)” to open
the Properties dialog.
h. In the center of the new dialog, click "Use the following IP address".
i. Add the "IP address" and "Subnet mask" as shown in Figure 12.
3. Add the TopWin software license to the machine. Obtain the Komax leadmaker license certificate, and
add the license key to the TopWin software on the Option Editor screen.
a.
Click “License on the right-hand side”. See Figure 13.
b.
Click “Add”, and enter the license key. See Figure 13.
Figure 13
4. Configure the settings for the station to enable the smart applicator functions.
NOTE
When configuring a station to have an applicator direct connection, make sure to select the appropriate USB device ID using
the Config button.
NOTE
If using the precision controller, make sure to enable the Air Feed option in the terminator configuration.
Configuration of Smart Applicator Option on Machine
1. Enter the Change Configuration screen. Refer to Figure 14.
Figure 14
Click To Enter
Change Configuration
Screen
Downloaded From
