TDK-Lambda GXE600 Series, Руководство по интерфейсу управления, Страница: 39 / 41

Communication GUI Guide
GXE600 Series
TDK-Lambda
<Page>
39/41
# Starting Address Qty. Function
15 PF Count 113 1 Register for PF count setting.
Set the time from when PF is detected until
when the PF signal is actually output.
When the output continues to be below the PF detection threshold for
more than the time set in the PF count register, the PF signal is output.
T he register setting value
Max. Min. Factory setting Unit
Integer data 100 0 0 ms
16 Automatic recovery time 114 1 Register for setting automatic recovery time.
Specify the waiting time until the output returns when
the protection function set for automatic recovery is activated.
If the protection factor continues to occur, the output is shut down
again after the automatic recovery time has elapsed.
T he register setting value
Max. Min. Factory setting Unit
Integer data 1000 100 100 10ms
Factory setting
：
100 x 10 ms = 1 sec
17 Erase Alarm History 115 1 Register for erasing alarm history.
Erase the contents of the alarm history register.
If the protection factor continues, the continuation factor bit
is set again after erasing.
T he register setting value
Erase No action Factory setting Unit
Integer data 1 0 - -
* T his register is write-only.
18 Slave ID 200 1 Register for setting the slave ID.
For each GXE connected to the communication bus line,
a unique slave ID must be set.
Before connecting to the communication bus line,
update this register value.
T he register setting value
Max. Min. Factory setting Unit
Integer data 247 1 1 -
* T o avoid misconfiguration, broadcast updates are ignored.
19 SCI Baud Rate 201 1 Register for communication speed setting.
The communication speed of GXE is specified
by the register value shown below.
T he register setting value
Set the communication speed to 2400 bps.
Set the communication speed to 4800 bps.
Set the communication speed to 9600 bps.
Set the communication speed to 19200 bps. *
*Factory setting
0
1
2
3
Data form
(0x00C8)
Data form
(0x00C9)
Value Overview
(0x0073)
Holding Register
(0x0071)
Data form
(0x0072)
Data form