TCL L32D2930, Руководство по обслуживанию, Страница: 30 / 50

Test and Alignment Specification for MT56EP1 Series (v0
01) 160825.docx
Page 22 of 25
then display them
¾ Select an available access point, then press “ OK/ ► ” to connect the TV to it
Note
⒄:
- If you select a protected access point, you will have to enter the corresponding password. Press “
OK ”
on the
remote control to display virtual keyboard to enable you to enter the password
2) “ Manual ” mode
¾ Select “ Wireless settings Æ Manual ”, then press “ OK/ ► ”, you will be prompted to enter the correct SSID
of an available wireless router to setup the connection
3) “ Auto ” mode
If your AP supports WPS (Wi-Fi Protected Setup), you can connect to the network via PIN (Personal
Identification Number) or PBC (Push Button Configuration). WPS will automatically configure the SSID and
WPA key in either mode.
¾
Select “ Wireless settings
Æ
Auto ”, then press “ OK/ ► ” to enter
ƒ Network Setup
¾ Press “ Menu ”on the remote control and select “ User menu Æ Network Æ Internet connection ”. Then press
“ OK/ ► ” key to select “ On ”. Wait untilthe connection is automatically established
¾ Select “ User menu Æ Network Æ Connection test ”, then press “ OK/ ► ” to check theInternet connectivity. If
failed, follow below steps toensure connectivity
¾ Select “ User menu Æ Network Æ IP settings ”, then press “ OK/ ► ” to enter into “ IP settings ” submenu
¾ Set “ Address type ”to “ Auto ” by pressing “ OK/ ► ” key, it will acquire and enter the new detected IP
address automatically
You can also follow below steps to enter your IP address manually
•
Set “ Address type ”to “ Manual ” by pressing “ OK/ ► ” key, then press “ ▼ ” key to go to the first entry field
•
Enter the “ IP address ”, “ Subnet mask ”, “ Default gateway ”, “ Primary DNS ”and “ Secondary DNS ”values.
Use remote control digital keys to enter numbersand “ ◄ / ► ” key to move from one to other field location
¾ After setting all required inputs, select “ User menu Æ Network Æ Connection test ”to check theInternet
connectivity again
¾ Select “ User menu Æ Network Æ Information ”, then press “ OK/ ► ” key to display current connection details,
such asInterface, Address type, IP address, etc..
See Appendix
⑿
“ How to upgrade Flash SW using Network ”
Please follow Appendix(11), make sure your TV is connected on the internet.
„ Update through the menu
¾
Select “ User menu
Æ
System
Æ
Software update
Æ
By network ”, then TV starts to search new software
automatically .If new software is detected, the page will show the button and hint that can guide you.