User manual TBK-NVR5004 TBK-VISION PLUS
42
www.tbkvision.com
11
Network Settings
Network Settings includes six submenus: network, sub stream, email, network server, NAT
and other settings. Network settings must be configured if the device is used for monitoring
over network.
11.1 Network
To set up network:
①
Go to Main Menu
Setup
Network
Network tab.
②
Set HTTP port. The default HTTP port is 80. If the value is changed, you shall add the
port number when typing IP address in IE address blank. E.g. If HTTP port is set to 82
and IP address is http://192.168.11.61, you should input http://192.168.11.61:82 into IE
browser.
③
Set server port. The default server port is 6036.
④
Connect internet. There are three ways to connect internet.
If you have a DHCP server running and would like your device to automatically obtain
an IP address and other network settings, check the checkbox beside “Obtain an IP
address automatically”. Then the device will distribute IP address, subnet mask, and
gateway IP and DNS server.
If you want to configure your own settings, disable “Obtain an IP address automatically”
item and input the IP address, subnet mask, gateway IP and DNS server.
If you connect internet through PPPoE, disable “Obtain an IP address automatically”
item and check PPPoE checkbox and then enter username and password. Once the setup
is completed, your device will automatically dial up into your network.
⑤
Test the effectiveness of the network by clicking “Test” button after you set up the
network.
⑥
If the network is well connected, please click “Apply” button to save the setting.
