User manual TBK-NVR5004 TBK-VISION PLUS
55
www.tbkvision.com
14
Remote Surveillance
14.1 Remote Surveillance via LAN & WAN
In order to view the NVR from a network it may be connected to a LAN/WAN or internet.
The network setup should be done accordingly.
14.1.1 LAN
①
Go to the NVR’s Main Menu
Setup
Network
Network tab to input IP address,
Subnet Mask, etc. If using DHCP, please enable DHCP in both the NVR and the router.
②
Enter Record Setup to set network video parameters like resolution, frame rate etc.
③
Open IE on a computer on the same network. Input the IP address of the NVR in IE
address bar and press enter.
④
IE will download ActiveX component automatically. Enter the username and password in
the subsequent window (the default username is admin; the default password is 123456).
Notice: If HTTP port is not 80, add the port number after IP address. For example, set
HTTP port as 82, input IP address like 192.168.0.25:82.
14.1.2 WAN
There are two ways for the NVR to connect to internet.
1. Connect the device to internet through router or virtual server.
①
Go to Main Menu
Setup
Network
Network interface to input IP address, Subnet
Mask, etc. If using DHCP, please enable DHCP in both the NVR and router.
②
Forward IP address and port number in Virtual Server setup of the router or virtual server.
Configure the firewall to allow accessing the NVR. (If you have enabled the UPnP
function in both the NVR and router, you can skip this step.)
③
If users want to utilize dynamic domain name, please apply for a domain name in a DNS
server supported by the NVR or router. Then add to the NVR or router.
This unit supports www.meibu.com, www.dyndns.com, www.no-ip.com and mintDNS type.
④
Open IE browser, input IP address, or dynamic domain name and enter. If HTTP port is
not 80, add the port number after IP address or domain name.
⑤
IE will download ActiveX automatically. Then a window pops up and asks for user name
and password. Input name and password correctly, and enter to view.
Note: If you cannot download and install ActiveX, please refer to FAQ Q8.
2. Connect the device to internet directly.
①
Go to Main Menu
Setup
Network
Network interface to enable PPPoE and then
