5-8
USER INTERFACE
Models 345, 346, 349, 355
User Interface
5
CO
2
Out Indicator
On the LCD, if the word OUT appears next to the word
CO
2,
there is a lack of CO
2
being supplied to the freezer.
The product light will also flash and a warning tone will
sound. This will continue until the CO
2
is replaced. If the
CO
2
is not replaced within 1 minute, the machine will
shut down and a fault message will appear.
Water Out Indicator
On the LCD, if the word OUT appears next to the word
WATER, there is a lack of water being supplied to the
freezer. In addition, the product light will flash and a
warning tone will sound. This will continue until the
proper amount of water is supplied to the freezer. If the
water is not supplied within 1 minute, the machine will
shut down and a fault message will appear.
Audio Alarm Silencer
The audio alarm will be disabled if the ALARM SILENCE
key is pressed. If a new fault or fault condition occurs or
the system mode changes, the audio alarm will be
re-enabled automatically. If the audio alarm is silenced
for more than 30 minutes without correcting the fault, it
will be re-enabled automatically.
Product Light
When the light is flashing, the product is not at serving
viscosity. This will occur during the initial freeze down, a
defrost cycle, a FAULT condition, power saver modes, or
anytime the product temperature is above 32°F (0°C).
Sampling Valve
The sampling valve is located behind the front drip tray.
The sampling valve is used to obtain a brix reading.
Daily Procedures
The following procedure should be performed daily.
1. Remove the splash shield, front drip tray, and center
drip pan.
2. Take these parts to the sink and brush-clean them.
3. Reinstall the parts onto the freezer.
AUTO
MODE
AUTO
OK
SYRUP
OK
T
U
O
-
R
E
T
A
W
K
O
-
2
O
C
AUTO
MODE
AUTO
OK
SYRUP
OK
T
U
O
-
R
E
T
A
W
K
O
-
2
O
C
