3-2
SAFETY
Models 345, 346, 349, 355
Safety
3
IMPORTANT!
An equipotential grounding lug is
provided with this machine. Some countries require the
grounding lug to be properly attached to the rear of the
frame by the authorized installer. The installation location
is marked by the equipotential bonding symbol (5021 of
IEC 60417-1) on both the removable panel and the
machine's frame.
WARNING!
Avoid injury.
•
DO NOT
allow untrained personnel to operate
this machine.
•
DO NOT
operate the machine unless all service
panels and access doors are restrained with
screws.
•
DO NOT
remove any internal operating parts
(including, but not limited to, machine door,
beater, or scraper blades), unless all control
switches are in the OFF position.
Failure to follow these instructions may result in severe
personal injury, especially to fingers or hands, from
hazardous moving parts.
WARNING!
This machine has many sharp
edges that can cause severe injuries.
•
DO NOT
put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
•
USE EXTREME CAUTION
when removing the
beater assembly. The scraper blades are very
sharp.
CAUTION!
This machine must be placed on a
level surface. Extreme care should be taken when
moving it for any reason. Two or more persons are
required to safely move this machine. Failure to comply
may result in personal injury or damage to the machine.
IMPORTANT!
Access to the service area of
the machine must be restricted to persons having
knowledge and practical experience with the machine, in
particular as far as safety and hygiene are concerned.
NOTICE!
Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please refer
to the cleaning section of this manual for the proper
procedure to clean this machine.
CAUTION!
This machine is equipped with a
refrigerated cabinet, designed to maintain product
temperature at or below 41°F (5°C). Before replenishing
the mix supply, the product must be refrigerated at or
below 41°F (5°C). Failure to follow this instruction may
result in health hazards and poor machine performance.
DO NOT
run the machine without product. Failure to
follow this instruction can result in damage to the
machine.
DO NOT
obstruct air intake and discharge openings. A
minimum of 3 in. (76 mm) of air clearance on both sides
of the machine is required. It is recommended to place
the rear of the machine against the wall to prevent the
recirculation of warm air. Failure to follow this instruction
may cause poor machine performance and damage to
the machine.
For Indoor Use Only:
This machine is designed to
operate indoors, under normal ambient temperatures of
70°F to 75°F (21°C to 24°C). The machine has
successfully performed in high ambient temperatures of
up to 104°F (40°C) at reduced capacities.
Noise Level:
Airborne noise emission does not exceed
78 dB(A) when measured at a distance of 39 in. (1.0 m)
from the surface of the machine and at a height of 62 in.
(1.6 m) from the floor.
!
!
!