Taylor-Dunn AN 171, Руководство по эксплуатации, устранению неисправностей и замене запасных частей

Страница: 69 / 206

Transmission
Transmission Page 9
TRANSMISSION ASSEMBLY
Remove and Install
6. Remove the motor wires.
7. Disconnect the brake linkage from the brake arm.
8. Remove the treadle linkage.
9. Remove the nuts from the four transmission mounting bolts. Do not remove the bolts at this
time.
10. Place jack stands under the left and right side of the front cowling.
11. Lift the rear of the vehicle just enough to allow the removal of the mounting bolts and remove
the bolts.
12. Raise the rear of the vehicle high enough to roll the transmission out from under the vehicle.
13. Lower the rear of the vehicle to the ground.
14. Install in reverse order.
15. Check brake adjustment and adjust as needed. Refer to
Adjust the Brakes
for information
regarding adjusting the brakes.
16. Reconnect the main positive and negative at the batteries, remove the blocks from the wheels,
and test drive.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
T
A Y
L OR - DU N
N
Th
e
B
e
st
W
ay
To
Go About
Yo
ur
Bu
si
n
e
ss
R