Tartan 4100, Руководство пользователя, Страница: 8 / 54

T4100 OM rev2
Page 8 of 50
After Launching:
9
Check bilge for water.
9
Check that engine exhaust is pumping water.
9
Verify operation of forward, neutral and reverse before leaving the dock.
To Be Done Prior to Turning Vessel Over to Owner:
9
Clean entire deck, including removing excess bedding compound from around fittings, which
may continue to ooze for a short time after shipment.
9
Check for deck leaks caused by shipping. NOTE: all boats are thoroughly checked prior to
shipment, but fittings can loosen under shipment and handling.
9
Touch up exterior teak finish if applicable.
9
Inspect and tighten engine shifter and throttle controls as needed.
9
Fill water tank(s) and check operation of water system for leaks as well as the hot water if
included.
9
Check head operation, holding tank and macerator pump. Operate bilge pump(s). NOTE: if auto
pump is installed, adjust switch level and ensure the auto switch is not blocked by bilge hoses.
Operate sump pump, shower and drain collection, and on some models sinks.
9
Check operation of all running lights.
9
All fluid levels in engine are to be checked after test run.
9
All gauges should be operational.
9
Operate galley stove and oven (every burner). Adjust regulator if necessary.
9
Adjust lifelines so they are taut.
9
Remove all traces of shipping tape.
9
Operate all winches and lubricate if necessary.
9
Check operation of all thru-hull fittings.
9
Operate all hatches and ensure that no binding occurs.
9
All interior doors, drawers, hatch boards, operated and planed down if necessary after rigging is
tensioned. A certain degree of swelling is to be anticipated. (This is not a warranty issue, part of
commissioning)
9
Check that all interior lights are operational.
9
Check the hoist on all sails and ensure correct halyard lengths as well as freedom of movement of
halyards, etc. Check and adjust operation of reefing system.