
T4100 OM rev2
Page 47 of 50
COMMISSIONING LIST:
The following is a list of minimum commissioning duties to be performed by both the boat
owner and the dealer. Additional operations may be required dependent on the model and
equipment thereon.
PRIOR TO LAUNCH:
Exterior:
Check hull, deck, shaft and keel, etc, for shipping damage and repair as needed. Prep bottom
and apply bottom paint including centerboard and inside of truck (if applicable).
Clean hull thoroughly.
Touch up boot and cove stripe where required
Wax topsides. (Gelcoat Only)
Check castle nut on prop shaft for cotter pin. (Folding and feathering props require additional
steps) Install zinc anodes.
Interior:
Charge and inspect batteries. (NOTE: Batteries are shipped from our plant with only partial
charge.)
Check hose clamps on ALL thru-hull hoses and tighten as required. Check that engine and
head have been de-winterized and that all drain plugs are in place.
Check oil level in engine and transmission and inspect shift and throttle linkages.
Boats with pedestal steering: Emergency tiller fitted and tested; Rudder stuffing box checked
for leakage with boat underway.
Flush bilge area thoroughly with fresh water and run pumps to flush out excess building dust
which settled during the shipping of the boat.
Clean bilge pump and sump pump strainers. (This will need to be done quite often in the first
several weeks)
Содержание 4100
Страница 11: ......
Страница 12: ......
Страница 13: ...6 0 W L...
Страница 47: ...T4100 OM rev2 Page 43 of 50 Tartan Yachts Commissioning Checklist...