Tartan 4100, Руководство пользователя, Страница: 7 / 54

T4100 OM rev2
Page 7 of 50
9
Check castle nut on prop shaft for cotter pin. (Folding and feathering props require additional
steps) Install zinc anodes.
Interior:
9
Charge and inspect batteries. (NOTE: Batteries are shipped from our plant with only partial
charge.)
9
Check hose clamps on ALL thru-hull hoses and tighten as required. Check that engine and head
have been de-winterized and that all drain plugs are in place.
9
Check oil level in engine and transmission.
9
Boats with pedestal steering: Emergency tiller fitted and tested; Rudder gater checked for leakage
with boat underway.
9
Flush bilge area thoroughly with fresh water and run pumps to flush out excess building dust
which settled during the shipping of the boat.
9
Clean bilge pump and sump pump strainers. (This will need to be done quite often in the first
several weeks)
Mast Stepping:
9
Attach upper shrouds loosely.
9
Attach backstay, leave turnbuckle extended.
9
Chock mast in partners. Refer to SPARTITE instruction for procedure.
9
Tighten the mast tie down rod(s) if necessary.
9
Attach headstay to stem fitting.
9
Use either main halyard or main boom topping lift to measure from side to side in vessel and
tighten upper shrouds so masthead is centered in boat. Before final tightening of upper shrouds,
check that proper upward angle of the spreaders has been maintained and go aloft to correct if
needed
9
Tighten backstay turnbuckle.
9
Tighten lower shrouds so mast is straight athwartships.
9
Tighten intermediate shrouds.
9
With rigging adjustments completed, install all cotter pins in the turnbuckle threads and re-check
that all cotters are in clevis pins and opened to 20
°
. Tape all cotter pins and unfair edges.
9
Install boom and rig mainsheet and topping lift. Check operation of the boom outhaul.
9
Connect mast wiring to terminals inside vessel and check operation of mast lights and electronics.