
T4100 OM rev2
Page 29 of 50
12.0 MAINTENANCE
Yachts kept shipshape and in good order require maintenance on a regular and frequent basis. The
frequency will depend upon the conditions under which the yacht is being used. You must continually
check the running and standing rigging, winches, engine, bilge and head as well
as surface finishes for
signs of needed maintenance. All deck hardware should be washed down with fresh water after sailing in
salt water.
12.1.1 Gelcoat Surfaces
Wash down the gelcoat surface of the hull and the deck regularly with fresh water and a good
detergent. A sponge or soft brush should be used on smooth surfaces, and a stiffer brush may be
used on the non-skid areas of the deck. Follow by rinsing with fresh water.
At least once a year the topsides of the hull should be waxed with a good automotive or boat
wax, then polished. This will help the gelcoat retain its color and appearance. Do not wax the
non-skid surfaces of the deck. Dark Gelcoat color hulls may require waxing at more frequent
intervals in order to prevent oxidation. Minor scratches in the gelcoated surfaces can be repaired
by buffing with a light abrasive buffing compound followed by waxing and polishing. Scrapes or
damages that have broken through the gelcoat surface can be repaired with the gelcoat repair kit,
which is provided with your yacht. For major damage, where a large area of the gelcoat has been
removed, or where the damage extends into the glass lamination below the gelcoat, consult your
Tartan Dealer or a qualified marine yard.
Gelcoat surfaces below deck are cleaned with a good detergent and water, then rinsed with fresh
water. These surfaces may also be waxed to maintain the appearance.
The galley and head sinks are fiberglass and can be maintained with the same care as other
gelcoat surfaces.
Gelcoat surfaces will stain if the yacht is moored where leaves fall on deck or birds roost. Under
these conditions, surfaces should be scrubbed down very frequently. A protective cover may
offer protection and reduce maintenance.
12.1.2 PPG Paints:
PPG Paints should be cleaned with warm water and a mild detergent. Lights scuffs in the PPG
finish can be buffed out using a light compound such as 3M Finesse It II Polish. Contact PPG for
care and maintenance guidelines on your PPG hull. Touch up kits are available through an
authorized PPG Dealer.
PPG DCC CONCEPT Acrylic Urethane
PPG Technical Assistance 1-800-647-6050
12.2 Portlights and Hatches
The portlights and hatches of your yacht are manufactured by various companies. The portlights are
stainless trimmed with safety glass or Lexan. Screen inserts are included. Lexan, which is impact-
resistant and very durable is used in the hatches as well as the companionway sliding hatch. However,
the surface of the Lexan is not abrasion resistant, and therefore, gritty cleaning agents should never be
used on them. Clean Lexan with mild soap and water. If Lexan requires polishing, Lexan polish is
available from most major hardware dealers. Toothpaste may be used as a substitute for Lexan polish.
Содержание 4100
Страница 11: ......
Страница 12: ......
Страница 13: ...6 0 W L...
Страница 47: ...T4100 OM rev2 Page 43 of 50 Tartan Yachts Commissioning Checklist...