
T4100 OM rev2
Page 32 of 50
closes and locks smoothly and securely. The splice at the end fitting should also be checked with each
sail. Rope sheets tend to fray over a period of time and should be replaced when any strand of the outer
layer of braid begins to fray.
12.8 Lifelines, Pulpits and Stanchions
Lifelines, like standing rigging, should receive regular, periodic inspections. The terminal ends at the
connector must be well screwed into the barrel in order that all the threads of the barrel are fully engaged.
The lock rings must be installed. Check the swaged ends for signs of rust. Check pulpits and stanchions
for dents or cracks. Ensure that they are properly secured into their bases.
12.9
Winches and Blocks
Most problems which develop in winches are due to insufficient or improper maintenance. When sailing
in salt water, winches should be stripped down, cleaned and lubricated no less than once a month. In
fresh water areas this maintenance procedure should be performed at least twice each season. The bolts
securing the winches should be checked at least once each season. Access to the bolts which secure the
cockpit winches may be gained by removing the winch drums. Bolts securing the winches on the
coachroof may be checked by removing the winch drums as well. If it is necessary to remove a winch
base and remove the bolts, the bolts should be resealed with marine sealant.
Blocks normally require little maintenance, but they should be examined regularly for damage,
particularly at the shackle connection. Never leave a snatch block open, and be sure the snatch is properly
closed before applying load so that the cheek of the block will not be bent. Sheaves and blocks can be
sprayed with a silicone lubricant to keep them running freely. The sheaves at the head of the mast should
be checked before the spar goes into the yacht at commissioning. These sheaves should also be checked
periodically during the season (this necessitates going up the mast in a bosun's chair) to ensure that they
are running freely and that the halyard is not cutting a groove in the sheave. The sheaves for the main and
genoa halyards have gar-fil bearings which do not require lubrication. All running rigging should be
washed down with fresh water after sailing in salt water.
NOTE : MOST DECK HARDWARE IS ATTACHED BY FASTENING BOLTS INTO
ALUMINUM PLATES FIBERGLASSED INTO THE DECK. THERE ARE NO NUTS
ON THE BACK SIDE OF THE DECK TO TIGHTEN. PLEASE CONSULT YOUR
TARTAN DEALER FOR MORE INFORMATION.
12.10 Engine
The maintenance of your engine is covered in the engine Owner's Manual, which should be read
carefully.
Note: Once the engine is started, it should be operated until it reaches full operating
temperature to prevent corrosion. This may take several minutes in cold water.
Before changing the oil, consult the engine Owner's Manual for complete instructions.
Routinely check fuel lines for tightness and integrity. Probably your nose is your best guide here. If you
smell fuel, there may be a leak somewhere in the system. A gentle tightening of each connection in the
fuel line will often solve the problem. If you smell fumes aboard, extreme caution must be taken to
prevent an explosion. Consult a qualified service mechanic immediately.
Содержание 4100
Страница 11: ......
Страница 12: ......
Страница 13: ...6 0 W L...
Страница 47: ...T4100 OM rev2 Page 43 of 50 Tartan Yachts Commissioning Checklist...