Target FS 1218 EX, Руководство по эксплуатации

Страница: 9 / 24

DRAFT
9
6.0 12 volt battery system
The fully automatic machines have a 12-v system where the battery and a safety main switch
are located inside the frame, and an Ammeter located outside upper rear cover.
The battery is fully loaded at delivery. Connect the battery cables to the battery electrodes.
Red to minus and black to plus. Turn the safety switch over to the position on and the
12 v systems are ready to be used.
Read instructions for the hydraulic systems and wire winch
carefully before you start to use any of the 12 V automatic systems.
The main switch shall always be turned of during breaks in the work,
transportation or storage.
6.1 Battery charger
The current electric system inside the operating panel has a battery charger
built- in.
Whenever electricity is connected to the input plug (15 at page 6) the
charger automatically loads the battery. The Ammeter indicates that the
charger is in work.
Note: When there is no reaction at the Ammeter see page 20.
Remember that the battery system is operating the lowering and raising frame,
support wheel and wire winch system. Heavy use can empty the battery faster
than the charger is loading the battery. In this case it only takes a short brake for
extra charging of battery.
Long time storage of the machine can also make influence on the battery condition.
An overnight charging can be recommended.
Note: A battery that is damaged or in bad condition is not indicated
by the ammeter.
For service and troubleshooting of the battery and battery charger: See page 20