23
D14049.05
February 2009
Grey Headline
(continued)
TANDBERG
VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction
Getting started
Overview and
status
System
configuration
VCS
configuration
Zones and
neighbors
Call
processing
Bandwidth
control
Firewall
traversal
Appendices
Applications
Maintenance
Initial configuration
Initial configuration using the front panel
The LCD panel makes it possible to configure
and check the IP settings as well as to reboot
the system. By default, during normal operation
the front panel will show the system name (if
configured) and one of the following IP address,
in order of priority:
LAN 1 IPv4 address
•
LAN 1 IPv6 address
•
LAN 2 IPv4 address
•
LAN 2 IPv6 address
•
Note that if the VCS is configured with a
system name or IPv6 address that is longer
than 16 characters, only the last 16 characters
will be shown in the panel.
To access the front panel menu options, press
ENTER
. The front panel LCD menu items are as
follows:
The steps opposite give an example of how to
use the front panel, in this case to configure
the LAN 1 IPv4 address. Use the same
procedure to configure the system's LAN 1 IPv4
subnet mask and IPv4 default gateway.
The IPv4 address and IPv4 subnet mask
configuration made using the front
panel applies to the LAN 1 port only. To
configure the system's IPv6 settings and (if you
have the Dual Network Interfaces option key
installed) the LAN 2 settings, you must use the
web interface or CLI.
IP Settings
Commands
IP Information
IP Address
IP Default GW
IP Netmask
Reboot
IP Address
Main Menu
IP Settings
Commands
IP Information
UP key
DOWN key
ESC
key
ENTER key
!
Press
ENTER
to produce the
Main
Menu
. Use
UP
/
DOWN
to navigate to the
IP Settings
submenu.
"
Press
ENTER
to access the
IP Settings
submenu.
#
Use the
UP
/
DOWN
keys to navigate to
IP Address
and press
ENTER
to select
this option.
$
Press
ENTER
again to produce the
cursor.
%
Use the
UP
/
DOWN
keys to move left and
right between the digits of the number.
&
When you reach a digit you wish to
change, press
ENTER
.
'
Use
UP
/
DOWN
to increase or decrease
the digit value. Press
ENTER
to select
the amended digit.
(
To amend the remaining digits, either
press
ENTER
to move to the right, or
ESC
then
UP
/
DOWN
to move to the right/left.
)
When you have finished editing press
ESC
twice to go to the
Confirm change
menu.
*
Use the
UP
/
DOWN
key to select
yes
or
no
followed by
ENTER
to confirm.
Use
ESC
to navigate back to the main
menu.
Repeat the process, selecting
IP Default
GW
to configure the default gateway and
IP Netmask
for the subnet mask.
After you have finished configuring the
VCS using the front panel, you must
reboot the system so that the settings
will take effect. To do this:
Use
1.
ESC
to navigate back to the
main menu (or
ENTER
from the main
display).
Use
2.
UP
/
DOWN
to navigate to the
Commands
submenu and press
ENTER
.
Press
3.
ENTER
again to select the
Reboot
option.
After a few seconds the red ALM LED to the
right of the front panel will light, and the
system will then reboot.
