TANDBERG M2/TT1220CIF/D, Инструкция по эксплуатации

Страница: 12 / 114

Introduction
Page 1-4 Instruction Manual: Professional Receivers and Decoders (IRD)
ST.TM.TT1220.1
The TT1220 range offers the following features:
•
Single QPSK RF input:
L-Band input
•
Or ASI input:
Factory selectable mounting of a DVB-ASI BNC input
•
Front panel controls and indications:
A 2 row by 20 character back lit LCD display provides information
and allows operator choice entry
Four pushbuttons provide the control interface in conjunction with
the LCD display
Single LED provides status information
•
Service selection:
Chosen from a menu list of available services carried in the
currently received transport stream in PSI/SI enabled mode.
•
Video decoding:
4:2:0 MP@ML mode support video resolutions up to 720 pixels x
576 active lines (25 frame/s) or 720 pixels x 480 active lines (30
frame/s)
No 4:2:2 support
Support for PAL- (B, D, G, H, I, M and Combination N)
Support for SECAM- (B, G, H, D, K, K1, L) Line ID
Support for NTSC (M)
2 x composite video outputs
•
Audio decoding:
According to MPEG-1 Layer I and II (Musicam)
Sampling rates 32, 44.1 and 48 kHz
All MPEG-1 Layer I and II bit-rates
1 x 9-pin D-sub output
•
Data:
Low speed data: RS-232 asynchronous (up to 115.2 kbit/s)
•
Conditional access:
In addition to product specific CA, all units offer BISS (mode 0
and 1) support
•
Vertical blanking interval (VBI) signalling support:
In 625 lines: VITS test lines, WST (EBU) Teletext insertion, VPS
and WSS is supported
In 525 lines: Closed captioning and V.Chip signalling are supported
•
Remote control:
RS-232, TANDBERG proprietary control solution
Options
3
•
Transport stream output:
3
Not all options available on all models. Some options only available when ordering as part of a new product. For
information about the different options and their availability, please contact your TANDBERG Television representative.
Software upgradeable options may incur a nominal fee.