TANDBERG M2/TT1220CIF/D, Инструкция по эксплуатации

Страница: 44 / 114

Operating the Equipment Remotely
Page 4-4 Instruction Manual: Professional Receivers and Decoders (IRD)
ST.TM.TT1220.1
Table 4.1: Configuring the Communication Parameters
Step Action Result
1. Go to the remote menu, located under
the Advanced, RS-232 Setup
submenu in the setup menu. The display will read “SET: REMOTE” on the top line.
2. Repeat pressing the up arrow, until you
are on the top line The display will read “Baud rate:” on the bottom line.
3. Press right once, and then by using the
up and down arrows, key in the desired
baud rate. The baud rate should be set to the same value as the
external control host.
4. Repeat for data bits, stop bits, parity
and flow control. All settings should be set to match the external control
host.
5. Once completed, the changes take
effect immediately.
Once the communication parameters are entered correctly, set the system
into remote mode for the external computer to gain control of the unit.
Table 4.2: Activating RS-232 Remote Control
Step Action Result
1. Go to the system options menu,
located under the Advanced submenu
in the setup menu. The display will read “ADV: SYSTEM OPTIONS” on
the top line.
2. Scroll until halfway down the menu,
where the item “Ctrl. Mode” is shown.
3. Press right once, and then by using the
up and down arrows, key in the desired
control mode, in this case: “remote”. The unit is now ready to accept remote control via the
RS-232 port.
4.1.4 Configuring the Unit for Remote Control Over the Air
(OAC)
For the unit to be controlled via OAC, the control mode of the TT1220
needs to be set to OAC.
Table 4.3: Activating OAC Remote Control
Step Action Result
1. Go to the system options menu,
located under the Advanced submenu
in the setup menu. The display will read “ADV: SYSTEM OPTIONS” on
the top line.
2. Scroll until halfway down the menu,
where the item “Ctrl. Mode” is shown.
3. Press right once, and then by using the
up and down arrows, key in the desired
control mode, in this case: “OAC”. The unit is now ready to accept remote control via the
OAC protocol.