TallyGenicom 6800 Series, Руководство администратора

Страница: 30 / 258

30
Chapter 3
The Control Panel
•
Eject Function — For pedestal models only, if the View key is pressed
for a long time (more than 1/2 second), the bottom of the last printed form
will move to the tear bar position as set by the Tear Bar Dist menu. The
message "READY TO TEAR/EJECT To Return" displays. While in this
position, pressing the UP or DOWN arrow keys moves the paper up or
down in 1/72 inch increments. Refer to the Up and Down key functions for
additional details on the microstep feature. When the VIEW key is
pressed a second time, the printer will move the paper either forward or
backward to enable printing on the next available form.
CANCEL
In offline mode, this key cancels all data in the print buffer. The print buffer is
cleared without printing any of the data and the current paper position moves
to the next top-of-form. If this function is disabled, the CANCEL key will be
ignored.
NOTE: Use of this key will cause loss of data .
TOF
Sets the top-of-form on the printer. This key is active only when the printer is
offline and will not operate if the printer is in a fault condition. The paper
moves down to the print position and aligns to the top-of-form. Refer to the
Quick Setup Guide for complete instructions on how to set the top-of-form.
CONFIG
In offline mode, CONFIG prints the current full configuration. This key requires
a confirmation with the ENTER key; pressing any other key will exit from this
function. See “Config Menu” on page 88 for an explanation of configuration
menus.
SELECT
In offline mode, this key allows for fast selection of any of the previously
stored configurations. Pressing this key causes the printer to cycle through
the following configuration load options: Factory, Cfg 1, Cfg 2, Cfg 3,..., Cfg 8.