Back to Table of Contents
21
9
Setting-up the Standalone unit
Once the units are hooked up you can set them.
Following are the steps for basic setup. For additional commands refer to the command list in
“Detailed instructions for Standalone Set-up” on page 30.
The general workflow of setting the unit is as follows:
Step 1.Press 3 times simultaneously on function keys 1 & 2 (each time will be followed by a short
beep and an orange led will be lit).
Step 2.Enter the 8 digit master code (the default number is 12345678). Then insert the relevant set-
up code (see next page).
Follow the task below for specific instruction of the tasks.
9.1
To use Proximity Card and Fingerprint mode:
Step 1.Press
1
key and
2
key 3 times simultaneously.
Step 2.Key in Master code (8 digits).
Step 3.Key in code
12
.
Step 4.Key in code
5
.
Step 5.Press
Enter
to save and exit.
9.2
Setting Proximity Card parameters:
Step 1.Press
1
key and
2
key 3 times simultaneously.
Step 2.Key in Master code (8 digits).
Step 3.Key in code
11
.
Step 4.Enter a string that is made up 6 digits where:
places 1,2 = the position in the string where the relevant code used
Input
Indicator signalling
1st 1&2
Short beep+2nd red led ON
2nd 1&2
Long beep+2nd red led ON
3rd 1&2
2 long beeps+2nd green led flashes
